Colt 1911 Reassembly 3D. Unsubscribe from dliz64? Cancel Unsubscribe. Dec 12, 2010 Colt 1911 3D reassembly. This feature is not available right now. Please try again later.
Reassembling I usually put the barrel back in the slide then put the barrel link forward, rest the spring with the part against the barrel link. Carefully put slide bk onto the frame letting the spring poke out of the front. Pull the slide back until the notches line up then insert slide stop. If it's not lined up usually you can wiggle the gun a little until it does then insert the slide stop. Put on barrel bushing then the spring cap.
Push the spring cap down while holding the frame and slide with one hand then turn the barrel bushing till it locks over the spring cap. It takes a bit of getting used to but once you've broke it down and reassembled it a few times its extremely easy.
Good luck and don't get frustrated it happens to us all when dealing with new guns. Reassembling I usually put the barrel back in the slide then put the barrel link forward, rest the spring with the part against the barrel link. Carefully put slide bk onto the frame letting the spring poke out of the front.
Pull the slide back until the notches line up then insert slide stop. If it's not lined up usually you can wiggle the gun a little until it does then insert the slide stop. Put on barrel bushing then the spring cap. Push the spring cap down while holding the frame and slide with one hand then turn the barrel bushing till it locks over the spring cap.
It takes a bit of getting used to but once you've broke it down and reassembled it a few times its extremely easy. Good luck and don't get frustrated it happens to us all when dealing with new guns.
Take the entire slide assembly and align with the lowerframe slots. Push the slide assembly onto the lower frame, and continue to slide backwards until the holes line up for the slide assembly lock lever. You should be able to see through the holes for the lock lever on both the slide assembly and the lower frame. Then notch on the slide assembly should also be lined up with the notch on the lower frame.Insert the locking lever to the slide assembly, and push the slide assembly forward into the cocked position.If done properly the slide assembly should not be able to slide off of the lower frame.
If it does remove the lock lever, check the hole alignment again, and re-attach the lock lever.
The button was pressed several times throughout the interview. Alex gordon family field. She didn’t and was met with a “drop” button that played the words “stupid bi” over the air.